The traditional method of adding a valve involves shutting down the main at the nearest valve locations, perhaps some distance away, then cutting in a valve.

Take advantage of what many municipalities, towns, and waterworks contractors have found.

Valve insertions allow you to add a valve to your system without turning water off.

There is:

• no water loss
• no need for temporary water to be set up
• no re-chlorination necessary and
• no disruption to consumers.

Valve insertions are available for: 

• PVC
• Cast Iron
• AC
• Steel (for 10 and 12 inch valve insertions)

Valve sizes range from 4 inches to 12 inches.

The procedure takes approximately 2-3 hours to complete, depending on conditions and watermain location.